If your mailbox is leaning like a tired old man or barely holding on after a few too many winters, it’s probably time for a new post. The good news? You don’t need to be a master carpenter to build a solid, good-looking mailbox post. With basic tools and a few hours on a weekend, you can build one yourself that’s sturdier, better-looking, and cheaper than the ones at the big box stores. Here’s how to do it.
What You’ll Need
- One 4×4 pressure-treated wood post (around 6–8 feet)
- One 2×4 pressure-treated board (around 3–4 feet)
- Wood screws (2½” and 3″)
- Exterior wood glue (optional)
- Post hole digger or shovel
- Bag of quick-set concrete
- Level
- Saw (circular or handsaw)
- Drill
- Tape measure
- Mailbox mounting bracket (optional)
- Paint or outdoor wood stain/sealant
Step-by-Step Instructions
1. Cut Your Wood
Cut the 4×4 post to the desired height—usually, about 6½ feet provides enough room for 2 feet underground and approximately 4½ feet above ground, which is the standard mailbox height.
From the 2×4, cut two pieces:
- One about 18–20 inches long for the arm (where the mailbox will sit)
- One about 6–8 inches long for the brace
Cut the end of the brace at a 45-degree angle on both sides so it fits nicely between the post and the arm.
2. Assemble the Post
Lay the 4×4 post flat on the ground. Position the arm horizontally at the top of the post and screw it in securely using wood screws. Next, attach the brace under the arm at a diagonal for extra support. You can add a bit of wood glue for extra strength if you want it rock solid.
3. Dig the Hole
Use a post-hole digger or shovel to dig a hole about 2 feet deep and 8–10 inches wide. Pour a few inches of gravel at the bottom for drainage.
Set the post in the hole and hold it level (use a level or eyeball it). Pour in the quick-set concrete and add water as directed. Use a scrap 2×4 to brace the post while the concrete sets, which usually takes 20–40 minutes.
4. Mount the Mailbox
Once the concrete has set, attach your mailbox to the arm using a mounting bracket or screws directly into the wood. Be sure to check local postal height and setback rules (usually 41–45 inches from the ground and 6–8 inches back from the curb).
5. Finish It Off
Seal the wood with outdoor stain, paint, or clear sealer to protect it from the weather. Let it dry before attaching the mailbox if you haven’t already.
That’s it—you’ve just built a clean, sturdy mailbox post with your own two hands. No fuss, no overthinking. It’s a simple project that makes a big difference in curb appeal and gives you that extra satisfaction every time you check your mail. Plus, it’ll outlast most of the prefab posts you’d find at the store.
Now go enjoy that fresh mailbox feeling. You earned it.