A chipped sink is one of those small problems that gets more annoying every time you see it. The good news is you do not need to replace your sink or hire a pro. With a little epoxy, some patience, and a few basic tools, you can make the chip disappear and keep your sink looking fresh.
Below is a clear, no-fuss guide to help you fix that chip and restore your sink’s surface.
What You Need Before You Start
You do not need much. Here is the simple list:
- Two-part epoxy for sink or appliance repair
- Fine-grit sandpaper
- Rubbing alcohol
- Cotton swabs or a clean cloth
- Painter’s tape
- A small applicator or toothpick for detail work
Gather everything before you start. It makes the process smoother and helps you avoid rushing.
Step 1: Clean and Prep the Area
Start by washing the chipped area with soap and water. Dry it well.
Next, wipe the spot with rubbing alcohol. This clears away any residue, allowing the epoxy to adhere without issue.
Next, wipe the spot with rubbing alcohol. This clears away any residue, allowing the epoxy to adhere without issue.
If the chip has loose fragments, gently sand the edges to remove any sharp edges. You are not trying to reshape anything, just create a clean edge.
Step 2: Protect the Surrounding Surface
Use painter’s tape to outline the chip. This keeps the epoxy from spreading where you do not want it. Clean lines make the final result look much better.
Step 3: Mix and Apply the Epoxy
Follow the instructions on the epoxy package. Most require equal parts mixed together until the color looks even.
Use a toothpick or applicator to press the epoxy into the chip. Keep the layer slightly raised. You will sand it down later. Work slowly. Smooth the top as much as possible so you have less work after it dries.
Step 4: Let It Cure Fully
This part matters. Do not rush it.
Most epoxy needs at least 24 hours to cure. Check the package for exact timing. Leave it alone during this time. No water. No poking. No testing.
Most epoxy needs at least 24 hours to cure. Check the package for exact timing. Leave it alone during this time. No water. No poking. No testing.
Step 5: Sand for a Smooth Finish
Once the epoxy has hardened, lightly sand it with fine grit sandpaper.
Your goal is to blend it with the sink surface so it looks natural and even. Take your time and check your progress as you go.
Your goal is to blend it with the sink surface so it looks natural and even. Take your time and check your progress as you go.
Wipe away dust when you are done. You should see a clean, solid repair with no rough edges.
When to Consider Repeating the Process
If the chip was deep or wide, you may need a second layer of epoxy. This is normal. Just repeat the steps and build the surface until it matches the rest of the sink.
A chipped sink does not have to be a permanent eyesore. With epoxy and a little care, you can repair the damage and keep your sink looking new. This small project saves money, feels satisfying to complete, and takes less effort than most people expect.